Prototyping is the service which gets your electronic solution into its first physical form as rapidly as possible. Time to market is always crucial with electronic products. We aim to get you a prototype within a week, and sometimes we can do it in 48 hours.
We have a number of solutions here that we can apply. If our E-Case range is suitable then we would recommend it on cost grounds. If you are designing your own circuit boards, then it makes sense to design them to fit our enclosures. In many cases, however, the boards already exist, and the new product is just an assembly of several boards with some custom software. In this case we can use a carrier plate and make a custom UnioBox to fit. Even so, the carrier plates and UnioBoxes are also offered in standard sizes, and prototyping will be quicker and easier if one of these is chosen.
When a product is about to be launched, it is essential that the sales push happens as soon as possible. In the old days the prototypes had to be built and photographed so that sales literature could be produced. Now we can produce sales literature before the product exists, because we can make photorealistic renderings of solid models. We can do this for any product that uses our enclosure systems using our Solidworks CAD system. Often the results are better than a photograph and the costs are less. Many of the images on this website have been made this way.
Perhaps you have already chosen a housing for your design, and just need some one to punch and print the end plates for you. We can do that too.